Step 1: measure the walls
Use a tape measure to find the height of the walls from skirting to ceiling, then the width of each wall. Multiply height by width for each one and add them together. For a simple rectangular room you can measure the full distance around the room (the perimeter) and multiply by the height instead. Write the numbers down as you go; it is easy to lose track of which wall you have measured.
Alcoves, chimney breasts and bay windows add extra wall area, so measure each face separately rather than guessing.
Step 2: take off doors and windows
Measure each door and window and subtract their area from the wall total. A standard internal door takes off a noticeable chunk, and a large window or patio door even more. If a room has lots of built-in wardrobes or tiled areas that will not be painted, take those off too. What is left is the area you actually need to cover.
Step 3: check the coverage on the tin
Every tin states its coverage, usually as square metres per litre. Divide your wall area by that figure to find how many litres one coat needs. Treat the number on the tin as a best case. It assumes a smooth, sealed surface and paint applied at the correct thickness. Rough, textured or very absorbent walls use more.
Step 4: decide how many coats
Most walls need two coats for even colour and full coverage, even when repainting in a similar shade. One coat often looks fine when wet but dries patchy, with roller marks and thin areas showing. Strong colour changes, especially going from dark to light or applying a deep red, yellow or orange, may need three. Multiply the litres per coat by the number of coats.
Things that change the amount
New plaster is thirsty. The first mist coat soaks straight in, so a freshly skimmed room uses noticeably more paint than a previously painted one. Covering a dark colour with a pale one uses more, and a tinted undercoat can save a coat of expensive topcoat. Textured surfaces such as old woodchip or rough plaster need more. Rollers with a longer pile also hold and apply more paint than short-pile ones.
Ceilings are worked out the same way: length times width. Woodwork is measured differently, by the length of skirting and the number of doors, and is usually done in a separate satin, eggshell or gloss.
Buying sensibly
Round up to the next tin size rather than down. Running out halfway through a wall and finishing from a new batch can leave a visible difference, especially with mixed colours. Buy all the paint for a room at once, and keep a little leftover, labelled with the room and colour, for touch-ups later.
A worked example in words
Imagine a bedroom with four walls. Measure the height once, then each wall width, multiply and add them. Take off the door and window. Divide the result by the coverage on the tin to get litres for one coat, double it for two coats, and round up to the nearest tin size. If the walls are freshly skimmed, add extra for the mist coat. If you are painting the ceiling too, measure its length and width and work it out separately, as ceiling paint is usually a different product.
Need it sorted? Book painting and decorating
LJAY’s can take this on for you. See the service or ask for a quote.
