What each one actually is
Traditional wet plaster is mixed on site and trowelled onto the wall in coats. On brick or stone, a thicker backing coat is followed by a thin finishing coat that is polished smooth as it sets. A skim is just that final thin layer applied over an existing surface.
Plasterboard is a factory-made sheet of gypsum faced with paper. It is screwed to timber or metal studs, or fixed to masonry with adhesive dabs, which is known as dry lining. The joints are then either taped and filled, or the whole surface is given a skim so it looks the same as a plastered wall.
Older Scottish homes and newer ones
Many older houses and tenement flats in Scotland have solid stone or brick walls finished with wet plaster, and ceilings of lath and plaster, where plaster was pushed through thin timber strips. These can last a very long time, but cracks, bulges and loose areas are common after a century or more.
Most homes built in recent decades use plasterboard for ceilings and internal walls, often with the outside walls dry lined too. Board is lighter, quicker to fit and easy to repair by cutting out and replacing a section. Knowing which you have helps decide the right fix.
When boarding is the better repair
If plaster is crumbling, coming away in large patches or sounds hollow across much of the wall, skimming over it only hides the problem for a while. Taking it back and boarding gives a firm, flat surface. The same goes for ceilings that are sagging or heavily cracked, where overboarding or replacing is usually the sensible option.
New stud walls, boxing in pipes and forming openings are naturally plasterboard jobs. Board can also straighten a very uneven wall where building it out with wet plaster would take several thick coats.
When a skim is enough
Where the existing plaster is well bonded but the surface is rough, patched, cracked in a few places or scarred after stripping paper, a fresh skim restores a smooth finish without disturbing the wall underneath. It is less disruptive than boarding and keeps the original structure intact.
Plasterboard walls that have picked up dents and repairs over the years can also be skimmed rather than replaced, as long as the boards themselves are firmly fixed.
Finish, mess and drying compared
Both can give a smooth, paintable finish when done well. Wet plastering involves more water and more dust from mixing and preparation, and backing coats take a long time to dry. A finishing skim is thin, so it dries much faster, though still needs time before decorating.
Taped and jointed plasterboard can be painted soon after the filler dries, which is why it is popular in new builds. Skimmed board sits in between. In every case, fresh plaster should be sealed with a diluted mist coat before normal paint goes on.
Insulated plasterboard
Some boards come with a layer of insulation bonded to the back. Fitted to the inside of a cold outside wall, they can make a room feel warmer. They take up a little floor space and need care around windows, sockets and ventilation, and on older solid walls the right approach to moisture matters. For anything beyond a straightforward room, it is worth getting specific advice on the wall type before choosing.
How to decide
Start with the condition of what is there. Sound wall, rough surface: skim. Loose or failing plaster, new wall or a tired ceiling: board, then finish. LJAY's handles drywall, skimming and the decorating afterwards, so Louise can look at the walls and suggest which route makes sense. Send photos through the contact page or call 07751 204847 for a quote.
