LJAY's Painting and Decorating Services

Homeowner guide

Repointing Cost: What Makes the Job Bigger or Smaller

Short answer

Repointing cost is mostly about labour: how much of the old mortar has failed, how carefully it has to be raked out, the type of brick or stone, the mortar it needs and how easy the wall is to reach. A low garden wall with a few eroded joints is a short job; a gable end with deep, crumbling joints and scaffold access is a much bigger one.

How much of the wall needs repointing

Pointing rarely fails evenly. Weather-facing walls, areas under leaking gutters and the bottom few courses that get splashed by rain usually go first. Repointing only the failed patches is quicker than doing the whole elevation, although on some walls a full repoint gives a more even look. The amount of wall involved is the starting point for any estimate.

Raking out: the slowest stage

Old mortar has to be removed to a sound depth before new mortar goes in. Soft, crumbling lime mortar comes out easily; hard cement pointing that was put on later is stubborn and has to be cut out carefully so the brick or stone edges are not damaged. That raking out often takes longer than the pointing itself, and it is the stage people most underestimate.

Brick, stone and the right mortar

Modern bricks with cement mortar are fairly straightforward. Older soft bricks and sandstone, common across Scotland, usually need a softer, breathable lime mortar so moisture escapes through the joints rather than the masonry. Lime is slower to work with and cure, and it needs protecting from frost and fast drying. Matching the colour of existing mortar can also mean mixing and testing samples first.

Joint style and finish

Joints can be finished flush, bucket-handle, weathered or recessed. Matching an existing style on part of a wall takes care so the repair blends in. Wide or irregular joints in rubble stone take longer than neat, consistent brick courses.

Access and the extent of repairs

Ground-level walls can be reached from the ground or a step-up. Higher walls need ladders, towers or scaffolding, which adds time and cost and may need a permit if it sits on a pavement. If bricks are cracked or frost-blown, they need replacing before repointing, which is covered on the brick and stone repairs page. Garden walls with loose copings or a lean are a separate issue to check before pointing.

Bricklayer cost per day or per job?

Some bricklayers price repointing by the day and others by the job. Either way, the figure comes from an estimate of how long the work will take. A fixed job price with the scope written down, which joints, which mortar, which finish, is easier to compare between quotes. Send LJAY’s photos of the wall, rough measurements and the location of the worst areas for a clear quote.

Signs your wall needs repointing

Look for mortar that is recessed well behind the face of the brick, joints that crumble when scratched with a key, gaps you can see light or daylight through, and plants growing out of the wall. Damp patches inside behind a weathered outside wall can also point to failed joints. Catching these early usually means a smaller repair, because once water gets into the joints, frost can start to damage the bricks or stones themselves and the job grows. A quick look after a winter of hard frosts is a good habit for any older wall.

Need it sorted? Book repointing

LJAY’s can take this on for you. See the service or ask for a quote.

Want a professional to handle it?

Request your quote

Include the area, rooms or surfaces involved and your ideal timing.

By sending this form you agree to our privacy policy.

FAQs

Common questions

Is repointing expensive?
It depends on how much mortar has failed, how hard the old pointing is to rake out, the mortar the wall needs and access. Small patches at ground level are modest jobs; full elevations with scaffolding are much larger.
Why does lime mortar repointing take longer?
Lime is worked more carefully and cures slowly, and it needs protecting from frost and from drying too fast.
Can I repoint just the bad areas?
Yes, patch repointing is common. The new mortar is matched in colour and joint style so it blends with the rest.
Does scaffolding change the cost of repointing?
Yes. Higher walls need towers or scaffolding, which adds hire, setup and time.
Call nowGet a quote