LJAY’s Painting & Decorating
Taping and Jointing Plasterboard
Plasterboard seams taped and finished.
Professional home finishes
Made to look right—and last.
Taping and jointing is a way of finishing plasterboard without a full skim coat. The joints between boards are reinforced with tape, then filled and feathered out with jointing compound until the seams disappear. It is common in new builds, extensions, partitions and commercial fit-outs where a fast, clean, paint-ready finish is needed.
How taping and jointing works
Tapered-edge plasterboard is designed for this method. Where two boards meet, the tapered edges form a shallow channel. Paper or mesh tape is bedded into the first coat of compound to bridge the joint, then further coats are applied, each wider and thinner than the last, and sanded smooth. Screw heads are spotted with compound in the same way. Internal corners are taped and external corners are protected with bead.
Taping and jointing versus skimming
A skim coat covers the whole surface in a thin layer of finishing plaster, giving a uniform hard finish. Taping and jointing only treats the joints and fixings, leaving the board face as it is. It is quicker, creates less moisture in the building and the surface can be decorated sooner. Skimming gives a slightly harder, more impact-resistant surface. The plasterboard vs plaster guide compares the two in more detail.
New build and commercial finishing
On new builds and commercial fit-outs, taping and jointing allows walls and ceilings to be finished quickly once the boards are up, so decoration can follow without long drying times. It suits stud partitions, new plasterboard ceilings and dry-lined walls. The stud walls and plasterboard ceilings pages cover the boarding side of that work.
Repairing cracked joints
Cracks along plasterboard seams are common once a building settles. Where the original joint was poorly taped, the crack is opened up, the tape renewed and the joint refilled and feathered so it does not reappear as quickly.
Preparing for paint
Board paper and jointing compound absorb paint differently, so a suitable drywall primer or sealer is applied before the finish coats to stop the joints showing through as dull stripes.
FAQs
Common questions
- Is taping and jointing as good as skimming?
- It gives a smooth, paint-ready finish and is widely used. Skimming produces a harder overall surface, so the choice depends on the room and how the wall will be used.
- Why can I see the joints through my paint?
- Usually the joints were not sealed before painting, so they absorb paint differently. A drywall primer before the topcoats prevents this.
- Can taped joints crack?
- They can when the building moves. Badly cracked joints are opened, retaped and refinished.
- What board is used for taping and jointing?
- Tapered-edge plasterboard, which has a recessed edge to hold the tape and compound flush with the face.
Have a project in mind?
